The electrical characteristics of the waterproof light touch switch on the middle and two feet are as follows:

1. Rated power: DC 12V 50mA

2. Contact resistance: 100M Ω Max;

3. Insulation resistance: 100M Ω Min;

4. Action force: 160+30gf;

250+30gf;

5. Service life: 100000 cycles;

6. Stroke: 0.25+0.05mm

7. Waterproof performance meets the requirements of IPX level 6 standard

8. When using in high humidity environments or environments with the possibility of condensation, to prevent leakage current between terminals, it is necessary to apply coating to cover the terminals after the switch is installed.

Regarding the problem of adhesion. If the waterproof touch switch is thin, it is necessary for plastic films to cooperate with each other. Many plastic films have poor heat resistance and may fall off after temperature control. However, assuming that imported plastic particles are used, it is not easy to fall off. Some domestic plastic particles may fall off very briefly, and it is also necessary to be careful when purchasing. The problem of falling off the outer cover is that the outer cover of the switch is on the back cover, mainly fixed by four riveting points. Assuming that the riveting points are loose, the outer cover will also fall off very briefly. Therefore, in order to avoid such difficulties, it is necessary to pay attention to two problems. Firstly, the base should be made of high-temperature resistant raw materials, and the riveting points should be fixed properly. By doing these two strategies well, this problem can be solved.

Waterproof, easy to touch, difficult to break. Switches are mostly exposed to the air, so in damp and cold temperatures, the shrapnel of the switch is easily oxidized, and the touch characteristics will greatly weaken in the future. Assuming we open the switch, we will notice a small black dot on the shrapnel, which is the actual effect of oxidation. Therefore, we usually place electronic devices in a dry area to avoid oxidation when not needed.

The purchase of light touch switch electronic devices in China attaches great importance to the problem of methods. Different types of electronic devices and their design styles are unexpected, and there are also inevitable differences in surface raw materials. Electronic devices made of lightweight raw materials are highly well-known in our specific days. If more careful inspection is carried out, we can carry out the selection and diligently safeguard our consumer interests.